Résumé
From 32 detailed cross sections through the gabbro unit of the Oman ophiolite, it is concluded that the thickness of this unit is on average 3.6 km. The lower layered gabbros represent two thirds, and the upper homogeneous foliated gabbros represent one third the gabbro unit. Assuming that the overlying basaltic lid (sheeted dikes and extrusives) is 1.5-2 km thick, the average crustal section in the Oman ophiolite is 0.5-1 km thinner than the standard 6-km-thick oceanic crust usually considered to be produced at fast spreading ridges, a point which is discussed. Variations in gabbro thickness between 5.4 km and 1.5 km are recorded. There is a general correlation throughout the ophiolite belt, particularly in the southeastern massifs, such that the thinnest gabbro units (2.2-2.5 km thick) overlay the thickest (300-700 m) transition zones which separate them from the mantle harzburgites and the thickest gabbro units (3.6-3.9 km thick) overlay the thinnest (5-100 m) transition zones. The combination of thinner gabbro units and thicker transition zones is observed above mantle diapirs or in domains which, following our structural models, were accreted above diapirs and have drifted in the spreading direction. If it is assumed that the extrusive basalt and the sheeted dike complex units have a constant thickness, such large variations indicate similar variations in the Moho level below the ridge of origin; in particular, the Moho above mantle diapirs should be some 1-1.5 km shallower than away from diapirs. As the Oman ophiolite is considered to derive from a fast spreading paleoridge, this doming should be detected in actual fast spreading ridges, as suggested by Barth and Mutter [this issue] and Wang et al. [this issue]. Copyright 1996 by the American Geophysical Union.