Abstract
Introduction: Several studies have documented the relationship between patellofemoral pain and patient dissatisfaction after total knee arthroplasty (TKA). However, few computer simulations have been designed to evaluate the patellofemoral joint during flexion. The aim of this study was to validate a new computational simulation, driven by forces and moments, and to analyze patellofemoral reaction forces and stress under squat loading conditions after TKA implantation.Hypothesis: This computational simulation of a squat using a model driven by forces and moments is comparable to in vitro and in silico data from the literature.Material and methods: We developed a finite element model of the lower limb after implantation of a fixed-bearing posterior-stabilized TKA. To simulate squat loading conditions when standing on both legs, an initial load of 130 N was applied to the center of the femoral head. Quadriceps force, patellofemoral contact force and Von Mises stress on the patellar implant, tibiofemoral contact forces and pressure on the tibial insert, and post-cam contact force were evaluated from 0° to 100° of knee flexion.Results: Quadriceps force increased during flexion, up to 6 times the applied load. Von Mises stress on patellar implant increased up to 16 MPa at 100° flexion. Tibiofemoral contact forces increased up to 415 N medially and 339 N laterally, with 64% distributed medially on the tibial insert. Post-cam contact started slightly before 70° of flexion.Discussion: In this simulation, tibiofemoral, patellofemoral and post-cam contact forces, and pressure distribution on the tibial insert were consistent with various published studies. This agreement suggests that computational simulation driven by forces and moments can reproduce squat loading conditions during knee flexion after TKA, without experimental kinematic data used to drive the simulation.Conclusion: This study represents an initial step towards validating tibiofemoral and patellofemoral mechanical behavior under squat conditions, from this computational simulation driven by forces and moments. This model will help us better understand the influence of various implantation techniques on patellofemoral forces and stress during flexion.Level of evidence:IV, biomechanical computational study.