Résumé
[Display omitted]
► Design of two different sol–gel procedures to prepare Cu–ZrO
2 catalysts. ► Cu
2+ ions incorporation shifts the crystallization of ZrO
2 to higher temperature. ► Textural and redox properties of Cu–ZrO
2 are related to the preparation route. ► Methanol conversion and yield to H
2 are influenced by the Cu precursor.
Cu/ZrO
2 catalysts prepared by the sol–gel method were characterized by XRD, N
2 adsorption, DTA/TG, TPR and N
2O dispersion measurements and tested as catalysts for the oxidative steam reforming of methanol (OSRM). Two synthesis procedures, based on the Cu precursors Cu(CH
3COO)
2·H
2O (
A-ZrCu samples) and Cu(NO
3)
2·2.5H
2O (
N-ZrCu samples) respectively, were compared to investigate the consequence of synthesis parameters on the physical and chemical properties of the prepared materials. The adopted procedures resulted in remarkable differences in thermal behaviour: the crystallization of tetragonal ZrO
2 was shifted to higher temperature in
N-ZrCu samples in comparison with pure ZrO
2, while this effect was not observed in
A-ZrCu. XRD data indicated that Cu
2+ ions were incorporated into the ZrO
2 lattice in
N-ZrCu samples.
Though both synthesis lead to very high surface areas, the textural properties of the reduced samples suggested the existence of different interactions between Cu ions and the ZrO
2 matrix in
A-ZrCu and in
N-ZrCu.
The Cu/ZrO
2 systems showed noticeable catalytic activity for the oxidative steam reforming of methanol, even without the pre-reduction treatment, but the catalytic response is drastically affected by the preparation procedure and the pre-treatments.
N-ZrCu samples gave higher methanol conversion and yield to H
2. Moreover, the distribution of secondary products was completely different:
N-ZrCu produced a lot of CO, while
A-ZrCu gave large amounts of CH
2O and (CH
3)
2O.