Résumé
Isomerization of glucose into fructose was performed in a batch mode in the presence of a series of alkaline solid catalysts such as cation-exchanged A, X, Y zeolites and hydrotalcites.
Under optimized operating conditions, water as the solvent, 95°C, up to 250
g/l of initial glucose concentration, up to 20
wt.% of catalyst , 700–1200
rpm and 8
bar of nitrogen pressure to avoid oxidation reactions, the reaction is not controlled by external or internal diffusional limitations. Among the different catalysts used, Li-, Na-, K-, Cs-, Ca- and Ba-exchanged A, X and Y zeolites, and hydrotalcites, Ca- and Ba-exchanged A, X and Y zeolites were found less selective, whereas those with a moderate basicity such as NaX and KX were found to achieve isomerization of glucose into fructose with a selectivity to fructose of about 90%, but at low glucose conversion, around 10–20%. However, the high selectivity to fructose is only obtained at glucose conversions lower than 25%. Furthermore, it was found that a significant amount of the cation passed into water (around 15% in the case of monovalent cation-exchanged X zeolites). This leaching phenomenon is no longer observed after a second run. The conversion of glucose is stabilized at about 10% without loss of selectivity to fructose, so that a continuous process may be considered.