Abstract
Ceria (CeO2) is known as a refractory oxide for dissolution in nitric acid, since the leaching reaction is thermodynamically unfavorable, except when it is complexed by nitrates but with very slow kinetics. To enhance dissolution, surface activation was achieved using high-energy milling. With the mechanically-activated cerium oxide, leaching in nitric acid reached 36%. The mechanical activation of the solid caused structural and microstructural changes (particle size, specific surface area, crystallite size, lattice strain, defects…). After one hour, the cleavage induced by energetic milling generated two populations: nanoparticles and grains containing defects like dislocations. Beside crystallite size and micro-strain evaluation using X-ray diffraction, cerium oxidation state was measured by Electron Energy-Loss Spectroscopy (EELS) analyses while linear defects were pictured by Transmission Electron Microscopy (TEM) observations. On one hand, it was found that the nanoparticles formed during milling process greatly enhance the dissolution reaction by the creation of Ce3+ thin layers of a few nanometer depth on their surfaces. On the other hand, it is shown that dislocations represent another way to increase the kinetics by activation energy. In conclusion, dissolution rate's growth can be due to different parameters like the leaching of the smallest particles, the presence of reduced oxidation state on nanoparticles and some highly reactive sites concentrating structural defects such as dislocation nodes. Finally, as ceria is also well known to be a safe analogue of PuO2, especially for dissolution studies, a solution for improving the dissolution of ceria would probably also be useful for dissolving the oxides rich in Pu.