Abstract
Hydrogen can be stored in the structure of nominally anhydrous minerals as point defects, and these impurities substantially modify many physical properties of Earth's mantle minerals. However, mantle rocks are composed of mineral grains separated by grain boundaries and interphase grains boundaries. Therefore, as a potential hydrogen reservoir, grain boundaries should be given proper attention. Here, I report an experimental investigation into hydrogen diffusion through grain boundaries in polycrystalline aggregates Sintering and diffusion experiments were performed using a gas-medium high-pressure vessel at under pressure of 300 MPa and over a temperature range of 900-1,250 degrees C. The diffusion assembly consisted of a polycrystalline cylinder of aluminous spinel + olivine crystals with a talc cylinder as the main hydrogen source. A Ni capsule was used to buffer the oxygen fugacity at Ni-NiO Experimental durations varied from 5 min to 5 h. The presence of hydrogen in the crystals was measured by Fourier-transform infrared spectroscopy. The calculation of the diffusion coefficients was based on the estimation of the characteristic distance. The absence or presence of hydrogen recorded by the 'hydrogen sensor' olivines embedded in the aggregate allows the estimation of bounds on this characteristic distance. Results presented here suggest that hydrogen effective diffusion coefficients are only one order of magnitude faster (similar to 10(-9) m(2)s(-1) at 1,000 degrees C) than in an olivine single crystal along the [100] axis. Resulting diffusion coefficients for hydrogen in grain boundary are four orders of magnitude faster than in a single crystal, but this diffusivity is not fast enough to affect hydrogen mobility in mantle rocks with grain sizes greater than similar to 1 mm. Thus, very limited chemical homogenization would occur using grain boundaries diffusion in mantle hydrous peridotite for incompatible and volatile element, such as hydrogen.