Résumé
This data report presents an uncommon study of fine drill cuttings (sand and gravels) recovered from hole maintenance operations in Ocean Drilling Program/Integrated Ocean Drilling Program (IODP) Hole 1256D (East Pacific Rise) during Expedition 335. Drill cuttings represent an integrated sampling of the entire hole and offer the opportunity to study the petrological characteristics of the various lithologies making up the upper oceanic crust. We selected the fine-grained fraction of cuttings coming from 12 pipe deployments (runs) and conducted microscopic observations (mineralogy and texture), image processing, electron microprobe analyses ( approximately 4400 analyses), and oxythermobarometry calculations on 16-25 grain-mount thin sections. This study shows that drill cuttings sample all of the lithologies in the hole (glass, aphyric and phyric basalts, dolerite, gabbro, diorite, gabbronorite, albitite, and three kinds of granoblastic basalt) but overrepresent non- or poorly recovered materials like albitites and granoblastic basalts. Drill cuttings are thus a good alternative to study these "rare" lithologies. Based on the composition of the main minerals and the oxythermobarometry calculations, two major lithologic groups were defined in the cuttings: a basaltic lavas-dolerites group and a gabbroic lithologies-granoblastic basalts group. Basaltic lavas (glass and basalts) and dolerites are characterized by Mg-augites rich in Al (sub 2) O (sub 3) , Cr (sub 2) O (sub 3) , and TiO (sub 2) ; MgO-rich plagioclases with a mean composition of An (sub 60-70) ; and titanomagnetites. Their Fe-Ti oxides (magnetite and ilmenite) indicate relatively reducing conditions (Delta NNO=-1.26 to -0.80), and clinopyroxenes in dolerites give a mean equilibrium temperature of 1017 degrees C. Gabbroic lithologies and granoblastic basalts are characterized by Ca-rich clinopyroxenes (augites and diopsides) depleted in Al (sub 2) O (sub 3) , Cr (sub 2) O (sub 3) , and TiO (sub 2) ; MgO-poor plagioclases with a mean composition of An (sub 50-60) ; and Ti-poor magnetites. Oxybarometers give oxidizing (Delta NNO=-0.08 to +0.58) to very oxidizing (Delta NNO=+1.97 to +2.38) conditions for these lithologies, and their pyroxenes indicate high (909 degrees C-985 degrees C) to relatively high (783 degrees C-888 degrees C) mean temperatures according to the thermometer considered. Albitites show equivalent mineral compositions and temperature and redox conditions to gabbroic lithologies and granoblastic basalts. They are, however, characterized by albitic plagioclases (An (sub 0-20) ) and usually display slightly lower temperatures (780 degrees C) and higher Delta NNO values (+2.66). One grain of gabbro Run14EXJB-T-G15) strongly differs from the other gabbroic grains ( approximately 40 grains) in terms of clinopyroxene composition, temperature, and oxidation state. This gabbro has thus probably suffered from peculiar processes compared to the other gabbroic lithologies.