Résumé
The circulation of CO2-rich solutions through fractured marl cores (caprock) under different flow rates and supercritical CO2 conditions (P-Total = 150 bar, pCO(2) = 61 bar and T = 60 degrees C) led to mineral changes caused mainly by calcite dissolution and to a lesser extent by aluminosilicate dissolution, and by gypsum precipitation adjacent to the fracture walls. Another significant result was the formation of the altered and highly porous zone (Davila et al., 2016a). Dissolution structures ranged from face to uniform dissolution and wormhole formation depending mainly on the flow rate.
2D reactive transport models were used to interpret the results of the percolation experiments (except at 60 mL h(-1)). They reproduced the variation in the outflow composition with time and the observed width of the altered zone along the fractures. A good match was achieved by using initial D-eff values in the rock matrix that ranged from 1 x 10(-13) m(2) s(-1) to 3 x 10(-13) m(2) s(-1) under slow flow rates. The D-eff value was higher by a factor of 20 (6 x 10(-12) m(2) s(-1)) under fast flow. Moreover, a slight variation in the calcite reactive surface areas contributed to the fit of the model to the experimental data.
The modeling results reproduced major dissolution of calcite and gypsum precipitation, and minor dissolution of clinochlore. Calcite dissolution was boosted by increasing the flow rate and gypsum precipitation increased at intermediate flow rate (1 mL h(-1)). Minor precipitation of dolomite, kaolinite, boehmite and three zeolites (mesolite, stilbite and smectite) along the altered zone occurred. The magnitude of these reactions was consistent with the measured increase in porosity over the altered zone. (C) 2016 Elsevier Ltd. All rights reserved.