Abstract
These last twenty years, the development of dense and highly sensitive seismologic and geodetic networks permits the discovery of new geophysical signals named non-volcanic tremor (Obara 2002) and slow slip events (Dragert et al., 2001). The combination of non-volcanic tremor and transient slow slip is commonly observed at plate interface, between locked/seismogenic zone at low depths and stable/ductile creep zone at larger depths (Dragert et al., 2004). This association defines episodic tremor and slip, systematically highlighted by over-pressurized fluids and near failure shear stress conditions. In this thesis we propose to combine a microstructural analysis of exhumed rocks with a modeling approach in order to accurately reproduce and understand the physics of episodic tremor and slip.We focus on continental rocks from the East Tenda Shear Zone (Corsica, France), a kilometer-wide localized Alpine shear zone that record HP/LT deformation (10kb / 400-450°C, Gueydan et al., 2003). Such pressure-temperature conditions are consistent with the location of episodic tremor and slip in subduction zone. Microstructural and EBSD analyses on these rocks describe a pattern of strain localization in centimeter-scale shear zones guiding by a grain size-sensitive creep. Microfracturing of the strong phase (feldspar here) and the sealing of these microfractures act, respectively, as grain size decrease and grain size increase processes.Most of recent modeling approaches of episodic tremor and slip are based on the rate-and-state variable friction law, describing slow slip event and non-volcanic tremor as slow shear slip on a plane. In contrast with such models, we wish to model the entire rock volume, with a ductile grain size-sensitive rheology guided by our microstructural observations (e.g. microfracturing and sealing as grain size variation processes). We hypothesize that slow slip events may result from ductile strain localization and not transient slip on fractures. Fluid pumping during strain localization may trigger whole rock fracturing at near lithostatic conditions that can be the signature of non-volcanic tremor. The 1D numerical model presented here will allow us to validate these assumptions.We also can predict pore fluid pressure variation as a function of changes in porosity/permeability and strain rate-dependent fluid pumping following the Darcy’s flow law. The fluid-enhanced dynamic evolution of microstructure defines cycles of ductile strain localization related to the increase in pore fluid pressure. We show that slow slip events can be ductile processes related to transient strain localization, while non-volcanic tremor can correspond to fracturing of the whole rock at peak of pore fluid pressure. Our model shows that the availability of fluids and the efficiency of fluid pumping control the occurrence of episodic tremor and slip. We also well predict the temperature and depth ranges of episodic tremor and slip: 400-500°C and 30-50 km in subduction zones and ~500°C and 15-30 km in strike slip settings, consistent with natural examples.As simplistic as it is, our field-guided mechanical model well describe, at first order, the relation between high pore fluid pressure, grain size-sensitive rheology and episodic tremor and slip. Some efforts remain to be done like a real fit of geophysical data (GPS) or the introduction of the new mineralogical assemblage, such as mafic rocks to reproduce oceanic environment.